Several different types of specialty coatings developed for
the DIY enthusiast are showcased within this area!
Electroplating System Tin Zinc
Electroplating
at home is easier than you think when you use this tin zinc electroplating system. The Eastwood Tin-Zinc Electroplating System
brings back the original brilliant luster to properly prepared metal parts, while providing a corrosion-resistant, protective
plating similar to chrome—but without the expense, hassles or hazards. Plate almost any metal part right at home, including
brass, copper, and steel (not for aluminum, die-cast, pot metal or stainless). How it works: Make sure parts are thoroughly
degreased and de-rusted before you start electroplating at home. Electroplating uses electrical current to pull small amounts
of metal from the positively charged tin-zinc anode bar, through the electrolyte solution, and onto the negatively charged
piece to be plated. Plating begins immediately once the piece is submerged into the solution. The longer the piece is submerged,
the heavier the plating on the piece will be. You may remove the piece from the solution to check the progress, then re-submerge
it for a thicker coating. The tin zinc electroplating process is complete when the piece is covered with a uniform dull gray
film. Then polish to a beautiful shine.
Electroplating
System Tin Zinc Item #10049 Z $69.99 + exchange
Calyx Manifold Coating
Make your vehicle's exhaust manifolds look new with Calyx. Easy to apply and long lasting. For optimum results, manifolds
should be removed, abrasive blasted, and wiped down with PRE, before applying. If you wish to apply while the manifolds are
installed on the engine, use a wire brush to remove surface rust and dirt, then wipe down with PRE. Apply Calyx with a rag
or toothbrush, and work it into the pores of the metal. For a buffed appearance, use a fingernail brush. Make your exhaust
manifolds look like new in a few minutes. Not as durable as our paint on coatings but convenient and easy to apply because
there's no disassembly required. Just remove loose rust and rub in thoroughly. Non-toxic and water-soluble. A little goes
a long way one container treats 8-10 typical V8 exhaust manifolds. Includes Instructions. Made in USA.
Calyx Manifold Coating Item # 11171
$19.99 + exc.
Gas Tank Sealer Kit For Cars
A clean supply of fuel is critical to the performance of your vehicle - hard starting, stumbling under load, and sluggish
response may be symptoms that your car's fuel system is dirty. The best way to ensure that the fuel is clean is to be
certain that the fuel tank is free of rust. This Gas Tank Sealer Kit seals minor leaks and can save you a great deal of time
and money in trying to locate a replacement tank. For metal tanks up to 20 gallons. Kit contains one 7 oz. can of Metal Wash,
1 pint of rust remover, two 16 oz. bottles of Gas Tank Sealer. Tank Tone (10030Z) resembles the original finish.
Gas Tank Sealer Kit For Cars Item #10165 Z $49.99 + exc
Gas Tank Sealer Kit For Cycles Item #10165 Z $33.99 + exc
Please call (902)888 2635 or (902)432 9219 *cell* with any questions.
Sparkles Auto Parts Restoration. Located in Summerside, PEI. Phone (902)888-2635
